Field results

Field Results – Drilling with slim motor BHA from floating rig

Drilling a slim hole from a semi-submersible in rough seas was almost impossible due to inadequate load on the heave compensator system. AST was called out to solve the problem.

Statoil solved a traditionally difficult task when the operator needed to drill a long section of cement as part of a well service job from the Borgland Dolphin semi-submersible.

Objectives

The 3 ½” PDM with a 4 1/8” PDC bit required optimal weight control to drill at 3000m under the Tordis subsea template. The combination of bad weather and heave made it an even more difficult operation and frequent stalls caused slow overall progress with concerns over losing the BHA. At TD it was found that the cement job did not qualify and the well was cemented back for the same interval to be drilled again. Now Statoil called on an Anti Stick-slip Tool (AST) to go on top of the BHA as the weather had not improved.

Results

The advantage of the AST was immediate and the stall-outs were replaced by freedom to increase the WOB to produce a faster Rate of Penetration (ROP). For all parameters, a very good comparison could be made as the AST tool was the only differentiating factor.

Run AST ROP Heave Stall-out circ. hrs
1 No 12 m/hr 3m Severe 28
2 Yes 19 m/hr 3m Minor 12

Value

The savings amounted to about one effective rig day or USD 0.4 Mill. although the biggest gain for Statoil was the reduced operational risk.

The Borland Dolphin semi on the
Tordis template drilling and
completing wells year-round.

Tool

3” AST

Client

Statoil

Country

Norway

Field

Tordis (Norwegian North Sea)

Rig

Borgland Dolphin

Section

4 ½” cement drillout

BHA

4 ½” bit (PDC) Weatherford CTD motor, AST, collars and 3 ½” DP

PrintPrint field result Send to friendSend to friend

Send to a friend